Life Fitness 93T - Manual (Page 7)

vi
Life Fitness Model 97Te, 95Te, 97Ti, 95Ti and 93T Arctic Silver Treadmills
GLOSSARY
Main Drive Belt Connects between the main drive motor pulley and the front roller pulley, and used
to transmit the driving power of the main drive motor to the front roller.
Main Wire
Harness Connected to the operating components of the unit to provide electrical power.
Motor Controller Regulates the speed of the striding belt.
Overlay Bezel A clear plastic covering over the display console.
PCB Programmable Circuit Board
Power Module Receives main electrical source from the wall outlet to distribute voltage throughout
the various electromechanical systems.
Polar Receiver Monitors heart rate.
Smart Stop
Sensor Senses the presence of an operator.
Rear Roller A free spinning roller with adjusting screws at each end of the roller used for
tensioning and centering the striding belt.
Rear Roller
Guards Located at the back of each side of the rear roller, are used as protective guards.
RPM Revolutions per minute.
Static Current Steady current flow.
Stop Switch A switch used to interrupt power going to the motor to stop the unit.
Striding Belt Sometimes referred to as the 'walking belt' and used to walk or run on.
Telemetry
Receiver A sensor that reads Heart Rate signal from the operator's chest strap transmitter.
Ties Plastic straps used to secure loose wiring to the main frame.
Wax/Lift Board A circuit board, which is located under the motor shroud, is used to communicate
input/output signals to and from the console, wax and lift motors, frame tag, and
motor.