How to... replace the lift motor – Life Fitness 93T User Manual
Page 139
3-24
Nut
Motor Tube
Bolt
Lift Frame
Life Fitness Model 97Te, 95Te, 97Ti, 95Ti and 93T Arctic Silver Treadmills
How To... Replace the Lift Motor
Special Service Tools Required: NONE
1. Turn the unit power OFF at the switch, and
then unplug the line cord at the wall outlet.
2. Remove the inside Upright Covers, Front
Cover, and Motor Cover. See “How To…” in
this section.
3. Cut off three Cable Ties securing the Cables to
the Cross-Member.
4. Disconnect the 4-Pin Connector from the Wax
Lift Board.
5. Disconnect the Lift Motor ground wire.
6. Remove the right Access Cover to avoid
damaging it, and then tilt the unit over on its
right side.
7. Remove the Bolt and Nut from the end of the
Motor Tube and Lift Frame.
8. Remove the Clip and Pin securing the Lift Motor to
the Cross-Member, and then remove the Lift Motor.
9. To install the new Lift Motor, make sure that
the Lift Carriage is activating the Home Switch
on 95Ti/e and 93T, and the Decline Switch on
the 97Ti/e. If necessary, adjust Threaded Shaft
Tube until the mounting holes are 13-3/4” apart
or aligned with the Carrier and Lift Motor.
10. Refer to Diagnostics Section to log
Maintenance Repair of the Lift Motor.
NOTE: Do not rotate the Threaded Shaft Tube
more than one full turn.
Lift Motor
Pin
Clip
Threaded
Shaft Tube
Lift Motor
Threaded
Shaft Tube
(Turn to adjust
to specified
length)