Life Fitness 93T - Manual (Page 151)

3-36
Line Filter
Transformer
Life Fitness Model 97Te, 95Te, 97Ti, 95Ti and 93T Arctic Silver Treadmills
How To... Replace the Line Filter
Special Service Tools Required: NONE
Note: If equipped with a Transformer, it must be removed first in order to
access the Line Filter below it. Before removing the Transformer, tag
and identify all wires.
Note: The Line Filter is located directly in front of the Drive Motor, and if
equipped, just below the Transformer. Before removing the Line Filter,
tag and identify all wires.
1. Turn the unit power OFF at the switch, and then unplug the line cord
at the wall outlet.
2. Remove Inside Upright Covers, Front Cover, and Motor Cover. See
“How To…” in this section.
3. If equipped with a Transformer, it must be removed first in order to
access the Line Filter below it. Before removing the Transformer,
tag and identify all wires.
4. Tag and identify all wires connected to the Line Filter, which is
located in front of the Drive Motor. With all wires properly
identified, disconnect them from the Line Filter.
5. Remove two screws securing the Line Filter at the base of the unit,
and then lift out the Line Filter.
6. Discard the old Line Filter, and install a new Line Filter in reverse
order. See Line Filter Wiring Schematic in Section 4.
NOTE: Do not over-tighten screws.