Life Fitness 93T - Manual (Page 119)

3-4
Rear Roller
Striding Belt
Letter “R”
Roller
Guard, LT
Roller
Guard, RT
Rear Roller
Adjusting Screws
Washer
Roller
Guard
Screw
Roller
Guard
Screw
Washer
Life Fitness Model 97Te, 95Te, 97Ti, 95Ti and 93T Arctic Silver Treadmills
How To... Replace the Striding Belt and Deck
Special Service Tools Required: NONE
1. Turn the unit power OFF at the
switch, and then unplug the
line cord at the wall outlet.
2. Remove the Front Cover. See
“How To…” in this section.
3. Remove four screws securing
Roller Guards, and remove the
Roller Guards from the Rear
Roller.
4. Remove the Rear Roller
Adjusting Screws.
Note: Index the initial position of
the Adjusting Screw or count the
number of rotations when
loosening the Roller Adjusting Screws for proper Striding Belt re-
tensioning.
5. Remove the Rear Roller out from under the
Striding Belt just enough to mark the end of the
shaft so that it can be re-installed in the same
way to maintain the same bearing wear pattern.
Using a felt-tip marker, mark the letter “R” on the
right end of the shaft.