Life Fitness 93T - Manual (Page 131)

3-16
OPTO
Mounting
Screws
OPTO
Sensor
OPTO Sensor
Wire/Connector
Tie Wrap
Bracket
Flywheel
Assembly
Life Fitness Model 97Te, 95Te, 97Ti, 95Ti and 93T Arctic Silver Treadmills
How To... Replace the Drive Motor OPTO Sensor
Special Service Tools Required: NONE
1. Turn the unit power OFF at the switch,
and then unplug the line cord at the wall
outlet.
2. Remove the inside Upright Covers, the
Front Cover, and the Motor Cover. See
“How to…” in this section.
3. Cut the Tie Wrap from around the
Bracket.
4. Remove two Mounting Screws securing
the Bracket to the top of the Motor.
5. Lift out the OPTO Sensor from between
the Flywheel Assembly and the Motor,
and discard.
6. Install new OPTO Sensor in reverse
order. Move the OPTO Sensor Bracket so
that the sensor is centered over the Chopper Wheel.