Slip rings, Maintenance, Warning caution – Lincoln Electric EAGLE SVM192-A User Manual
Page 30: Warning
MAINTENANCE
D-4
D-4
EAGLE™ 10,000
ENGINE ADJUSTMENTS
OVERSPEED IS HAZARDOUS
The maximum allowable high idle speed for this
machine is 3750 RPM, no load.
Do NOT tamper
with governor components or setting or make any
other
adjustments
to
increase
the
maximum
speed. Severe personal injury and damage to the
machine can result if operated at speeds above
maximum.
------------------------------------------------------------------------
Adjustments to the engine are to be made only by a
Lincoln Service Center or an authorized Field Service
Shop.
SLIP RINGS
A slight amount of darkening and wear of the slip rings
and brushes is normal. Brushes should be inspected
when a general overhaul is necessary.If brushes are to
be replaced, clean slip rings with a fine emery paper.
Do not attempt to polish slip rings while engine is
running.
------------------------------------------------------------------------
WARNING
CAUTION
BATTERY
1.
When replacing, jumping, or otherwise connecting
the battery to the battery cables, the proper
polarity must be observed. Failure to observe
the proper polarity could result in damage to the
charging circuit. The positive (+) battery cable
has a red terminal cover.
2.
If the battery requires charging from an external
charger, disconnect the negative battery cable
first and then the positive battery cable before
attaching the charger leads. Failure to do so
can result in damage to the internal charger
components. When reconnecting the cables,
connect the positive cable first and the negative
cable last.
GASES FROM BATTERY can explode.
• Keep sparks, flame and cigarettes away from battery.
To prevent EXPLOSION when:
• INSTALLING A NEW BATTERY - disconnect negative
cable from old battery first and connect to new battery
last.
• CONNECTING A BATTERY CHARGER - Remove bat-
tery from welder by disconnecting negative cable first,
then positive cable and battery clamp. When rein-
stalling, connect negative cable last. Keep well venti-
lated.
• USING A BOOSTER - connect positive lead to bat-
tery first then connect negative lead to engine foot.
BATTERY ACID CAN BURN EYES AND SKIN.
• Wear gloves and eye protection and be careful when
working near battery. Follow instructions printed on
battery.
WARNING
ENGINE MAINTENANCE PARTS
HARDWARE
Both English and Metric fasteners are used in this
welder.
KOHLER C23S
KOHLER 12 050 01
Oil Filter
FRAM PH8172*
Air Filter
KOHLER 47 083 03
Element
FRAM CA79
Air Filter
KOHLER 24 083 02
Pre-Cleaner
Fuel Filter
KOHLER 24 050 10
Spark Plugs
CHAMPION RC12YC
(Resistor
(.030” GAP)
Type)
*
Oil capacity increases from 2.0 Qts. to 2.1
Qts. when using this filter.