KTI Networks KS-2601 - Manual (Page 69)

65
packet storm. You can enable the storm control by port. Follow the steps to do
the storm control settings.
1. Set the suppression rate.
2. Select which storm will be controlled and which ports will be applied – all of
the ports, none of the ports or selected by port in the table.
3. If “By Port” is selected, select the ports that will apply the storm control.
Note:
Broadcast – it is ”one to all” traffic. Every port will receive the packets.
Flooding - it is “one to all” traffic caused by Mac address not found in the switch.
Every port will receive the packets.