KTI Networks KS-2601 - Manual (Page 32)

28
For Auto Detect mode, the switch will always keep auto-negotiation function
ON but just modify its attribution if the auto mode of port is disabled. The
Auto-MDIX function will be always enabled in this mode.
For applications, you should select Auto Detect mode if the connected device
is auto-negotiation enabled. And you can select Auto Negotiation mode if
the connected device is auto-negotiation disabled.
For most applications, Auto Detect mode is OK. But for 100FX connection,
you should select Auto Negotiation mode and disable Auto. Set the port to
100/Full.
3.6 show cfg command will show Model Name, Mac ID of the switch and
Firmware version. For example,
>show cfg
[System Configuration]
Company Name :
Model Name : Intelligent Switch
MAC Address : 00:00:01:23:45:67
Firmware Version : 3.02.02 < Mar 13 2006 15:13:36 >
3.7 show dot1x command will show current 802.1x status and settings.
Its syntax is . . .
>show dot1x
Syntax: show dot1x [config|radius|port]
config : show 802.1x protocol settings
radius : show settings for radius server
port : show ALL ports status
For example,
>show dot1x config
[802.1x Protocol Configuration]
============================================
802.1x Protocol : Disabled
Re-authentication : Disabled
Re-authentication Timeout Period: 3600
Re-authentication Max Count : 2
Max Request Count : 2
Server Timeout Period : 30
Supplicant Timeout Period : 30
Quiet Timeout Period : 60
Tx Timeout Period : 30
============================================
>show dot1x radius
[Redius Server Configuration]
====================================================
Redius Server IP Address : 192.168.1.222
Redius Server Port Number: 1812
Shared Key : 12345678
====================================================
>show dot1x port
[802.1X Port Authentication Configuration]
=================================