KTI Networks KS-2601 - Manual (Page 42)

38
This switch supports TFTP protocol for firmware and configuration update and
backup. You should select backup firmware or configuration first. And provide
the IP address of the TFTP server and the backup file name for the backup
operation.
Enter “backup” at the prompt, the command syntax will be shown.
>backup
Syntax: backup [firmware | config] ip filename
For example, “backup config 192.168.1.80 abcd” will backup the configuration
to TFTP server 192.168.1.80 and its file name is “abcd”.
11. upgrade command
This switch supports firmware or configuration upgrade with TFTP protocol.
This command is used to upgrade firmware or configuration to the switch.
Its syntax is . . .
>upgrade
Syntax: upgrade [firmware | config] ip filename
ip is the IP address of TFTP server.
filename is the upgrade file name in the TFTP server.
For example, “upgrade config 192.168.1.80 abcd” command will load file
“abcd” from TFTP server 192.168.1.80 as its configuration setting.
12. exit command
This is a logout command – the same as Logout command.
13. logout command
This is a logout command – the same as Exit command.