Kenwood RC-D710 - Manual (Page 9)

MEMORY CH-
STORINg ODD-SPLIT REPEATER FREquENCIES
Some repeaters use a receive and transmit frequency pair
with a non-standard offset. To access those repeaters,
store two separate frequencies in a memory channel. You
can then operate on those repeaters without changing the
offset frequency you stored in the menu.
1 Set up a simplex channel by following steps 1 to 6 of
“STORING SIMPLEX AND STANDARD REPEATER
FREQUENCIES”, above.
2 Press [VFO] to enter VFO mode.
3 Rotate the Tuning control to select your desired
transmit frequency.
• Additionally, you can press the microphone [UP]/[DWN]
keys to select a frequency.
4 Set up any additional data desired for the transmit
frequency.
• Tone ON/OFF, Tone frequency, CTCSS ON/OFF, CTCSS
frequency, DCS ON/OFF, DCS code, etc.
5 Press [F].
• A memory channel number appears.
6 Rotate the Tuning control to select your desired
channel number.
• Additionally, you can press the microphone [UP]/[DWN]
keys to select a channel.
7 Press [PTT], [M.IN] to store the data in the selected
Memory channel.
n Call Channel Memory (Odd-Split)
The Call channel can be used to store any frequency
and related data that you will recall often. You may
want to dedicate the Call channel as an emergency
channel within your group.
To store an odd-split frequency and related data as the
Call channel instead of in a Memory channel, after step
6 (above), press [PTT], [C.IN].
Note: You cannot store the transmit offset status and Reverse
status in an odd-split Call channel.
RECALLINg A MEMORY CHANNEL
1 Press [MR] to enter Memory Recall mode.
2 Rotate the Tuning control to select your desired
Memory channel.
• Additionally, you can press the microphone [UP]/[DWN]
keys to select a channel, or you can enter a channel
number using the microphone keypad.
n Memory Recall Method
The transceiver Menu also provides you with the option
to recall Memory channels with stored frequencies in
your current band, or all Memory channels:
1 Enter Menu mode and access Menu 201.
2 Set the recall method to CURRENT (current band)
or ALL BANDS (all bands).
• CURRENT allows you to recall only those memory
channels that have stored frequencies within the
current band. ALL allows you to recall all programmed
memory channels.
• When the recalled memory channel is an AM channel,
you cannot recall on the B band.
Frequency ranges:
• 118 MHz: 118 ~ 135.995 MHz
• 144 MHz: 136 ~ 199.995 MHz
• 220 MHz: 200 ~ 299.995 MHz
• 300 MHz: 300 ~ 399.995 MHz
• 430/440 MHz: 400 ~ 523.995 MHz
• 1200 MHz: 800 ~ 1299.990 MHz
CLEARINg A MEMORY CHANNEL
1 Press [MR] to enter Memory Recall mode.
2 Rotate the Tuning control to select your desired
Memory channel.
• Additionally, you can press the microphone [UP]/[DWN]
keys to select a channel, or you can enter a channel
number using the microphone keypad.
3 Turn the transceiver power OFF.
4 Press [MR] + Power ON.
• A confirmation message appears on the display.
5 Press the Tuning control to clear the Memory channel.
• To exit without clearing the channel, press [ESC].