Kenwood RC-D710 - Manual (Page 13)

PM-
AutO PM chAnnEL stORE
After you recall a PM channel, this function automatically
overwrites the current PM channel with the present
operating environment when:
• You recall another PM channel.
• You press
[PM].
• You switch the transceiver power OFF.
Follow the steps below to activate the Auto PM storage
function.
1 Enter Menu mode and access Menu 521.
2 Set to ON.
Note: If you do not recall a PM channel (1 - 5), Menu No. 521 will not
appear on the display.
PM chAnnEL REsEt
To reset the PM channels to their default settings:
1 Turn the transceiver power OFF.
2 Press [F] + Power ON.
3 Release [F].
4 Rotate the Tuning control and select PM RESET.
5 Press the Tuning control.
• A confirmation message appears on the display.
6 Press the Tuning control again to reset the PM
channels.
• Press [BACK] to return to the previous display.
• To exit without resetting the PM channels, press [ESC].
stORinG DAtA in PM chAnnELs
1 Confirm that the following conditions have been
satisfied:
• The transceiver is in receive mode.
• Scan is not being used.
• Microphone Control is OFF.
2 Configure the transceiver with your desired settings.
3 Press [F], [P.IN].
• PM channel numbers 1 to 5 appear and blink at the bottom
of the display.
4 Enter a channel number ([1] to [5]) corresponding to
your desired PM channel.
• The settings are stored in the PM channel.
REcALLinG PM chAnnELs
1 Press [PM].
• PM channel numbers 1 to 5 and OFF appear on the
bottom of the display.
2 Enter a channel number ([1] to [5]) corresponding to
your desired PM channel.
• The settings stored in the PM channel are recalled.
• The selected channel number appears on the display.
• When selecting [OFF], the PM channels turn off.