beautypg.com

Aprs, Accessing received aprs messages, Transmitting a message – Kenwood RC-D710 User Manual

Page 44

background image

APRS-

[ALLCLR]: Clears all digits and backs the cursor to the

first digit.

6 Rotate the Tuning control to select the first digit.

• You can enter alphanumeric characters plus special ASCII

characters.

7 Press the Tuning control.

• The cursor moves to the next digit.

8 Repeat steps 6 and 7 to enter up to 67 digits.
9 Press the Tuning control to complete the setting.
The keypad on the microphone also is available to enter

alphanumeric characters in steps 3 and 6.

ACCeSSing ReCeiVeD APRS meSSAgeS

This transceiver is capable of storing a maximum of 100

messages in memory. You can easily access one of

those.
1 Press [KEY], [MSG] (or [MSG]).

• The newer message the smaller number assigned; the

latest message is assigned 1.

[POS]: Displays the latest position data of the current

station, if stored in memory.

2 Rotate the Tuning control to select the desired

message using the cursor (s).

3 Press the Tuning control.

• If you select an incoming message, the following display

appears:

[BACK]: Restores the list of messages.
[NEW]: Create a new message.
[REPLY]: Responds to the party from whom you

received. Enters into message setting.

[SEND]: Messages in the list that have not been sent

are transmitted.

[POS]: The position data of the transmitting station is

displayed (if the station data is available).

[CLR]: Deletes the current message.

• If you select one of your outgoing messages, the following

display appears:

[BACK]: Restores the list of messages.
[NEW]: Create a new message.
[EDIT]: Responds to the party from whom you

received. Enters into message setting.

[SEND]: All messages which can be transmitted will be

sent 1 time.

[RE-TX]: When pressed for a message assigned

a period (.), resets the retry counter to 5 more

transmissions.

[CLR]: Cancels further transmissions of the current

message.

The table below shows the meanings of the symbols

to be shown in step 2.

q

Meaning

Message addressed to you

B

Bulletin message

!

Report by the National Weather Service

w

RX or TX?

Received message (or bulletin)

A message (or bulletin) for transmitting

e

Status

n

1

“n” indicates the remaining number of times

for transmitting the message (or bulletin).

1

A message for which a reception

acknowledgment was returned

.

1

A message (or bulletin) transmitted

5 times (For a message, a reception

acknowledgment was not returned.)

1

These indicators appear for outgoing messages (or bulletins).

tRAnSmitting A meSSAge

When you press

[SEND] on the “MESSAGE LIST” display,

the remaining messages on the Message List will be

transmitted.

After entering a message on the message display,

pressing the

Tuning Control will cause it to transmit every

minute.

Not-yet-read

indicator

Time (message received)

Sequence