Kenwood RC-D710 - Manual (Page 36)

PACKET-
Command Name Short Description Parameter Default
NPATH NPATH
Specifies digipeater call signs to be added when the
UISSID parameter in a received packet is 8 or 12.
Call1, ... call7 −
NTSGRP NTSGRP Specifies a group code to be used for making a
$PNTS sentence.
0 ~ 3 characters −
NTSMRK NTSMRK Specifies a mark number to be used for making a
$PNTS sentence.
0 ~ 14 0
NTSMSG NTSMSG Specifies a message to be used for making a $PNTS
sentence.
0 ~ 20 characters −
OVERKILL OVE
Specifies the number of old messages to be deleted
when the TNC mailbox does not accept a new
message because the memory is full.
0 ~ 255 0
PACLEN P
Specifies the maximum length of the data portion of a
packet.
0 ~ 255 128
PACTIME PACT
If set to EVERY, sends a packet at intervals of the
specified period (n). If set to AFTER, sends a packet
only once after the specified period (n). The unit of n
is 100 milliseconds.
EVERY/ AFTER n
(n = 0 ~ 250)
AFTER 10
PERSIST PE
Specifies a parameter to calculate probability for the
PERSIST/SLOTTIME method.
0 ~ 255 128
PPERSIST PP
Causes the TNC to use the PERSIST/SLOTTIME
method when ON, or the DWAIT method when OFF.
ON/ OFF ON
RAMTEST RAMTEST Checks the RAM after clearing it. − −
READ R
Specifies one or more message numbers to be read
from the TNC mailbox.
− −
RESET RESET Restores the default status for all the commands. − −
RESPTIME RES
Specifies the acknowledgment packet transmission
delay. The unit of the parameter is 100 milliseconds.
0 ~ 250 5
RESTART RESTART Causes the TNC to function as if it is switched OFF
then ON.
− −
RETRY RE Specifies the number of transmission retries. 0 ~ 15 10
ROUTE ROU
When ON and receiving a packet forwarded by a
PBBS, leaves the included route information.
ON/ OFF ON
SENDPAC SE Specifies a character which forces a packet to be sent. 0 ~ $7F $0D
SLOTTIME SL
Specifies the period of random number generation
intervals for the PERSIST/SLOTTIME method. The
unit of the parameter is 10 milliseconds.
0 ~ 250 3
SPATH SPATH
Specifies digipeater call signs to be added when the
UISSID parameter in a received packet is 9 or 13.
Call1, ... call7 −
STREAMCA STREAMC
When ON and multiple connections take place,
receiving a packet causes the TNC to display the call
sign.
ON/ OFF ON
STREAMDB STREAMD When ON, causes the TNC to display a stream switch
character included in a received packet.
ON/ OFF OFF
STREAMSW STR Specifies a character to be used for switching streams. 0 ~ $7F $01
TOUT TOUT
Specifies the time-out time of the TNC mailbox. When
no packet is received within the specified time, a
disconnect takes place. The unit of the parameter is
10 seconds.
0 ~ 250 30
TRACE TRAC
When ON, causes the TNC to display all received
packets in their entirety.
ON/ OFF OFF
TRANS T
Causes the TNC to exit Command mode and enter
Transparent mode. To restore Command mode, press
and hold [Ctrl], then press [C] three times.
− −