Kodak 6B7198 - Manual (Page 87)

Using the Long Roll Accessory
May 2002 D-23
Appendix D-1: Calibrating the Sensor Offsets
IMPORTANT: Do this procedure only if you will be using SAM to operate the
scanner.
Do this procedure twice, once for the left sensor and once for the right sensor. For
best visibility, use the largest film format you have.
It is not necessary to prepare and load the film twice.
Preparing and Loading the Film
1. Create a roll of film with the center of several frames clearly marked.
2. Edit the roll of film, making sure to center the mark in the crop box on the
editor.
3. Load the edited film, beginning at the left side of the scanner (see Loading
and Threading Film on page D-16).
4. In SAM, select View>Film Controls.
5. Click Load Film.
6. When the dialog box appears, click OK.
center