KORG STAGE VINTAGE SV-1 - Manual (Page 39)

Using the SV-1 | Selecting and editing the effects – 25
English
NOTE: Extreme DRIVE settings may cause unwanted distortion. If this happens,
lower its setting.
5. Use the TYPE knob of the MODULATION FX section to select a different
modulating effect (chorus, phaser, flanger or rotary speaker). If the rotary
effect is selected, use the SLOW/FAST button to change the rotor’s speed.
You can change the speed of the modulation (or horn rotation) by using the
SPEED knob, and the intensity (or horn acceleration) by using the INTENSITY
knob. To return to the default settings, press the SPEED or INTENSITY knob.
HINT: If you select the rotary effect, and a footswitch pedal is connected to the
PEDAL 1 jack on the back of the instrument, you can use the pedal to switch the
rotor speed between the SLOW and FAST settings.
6. Use the TYPE knob of the REVERB/DELAY section to select a different
reverb, echo or delay effect.
If the stereo delay effect is selected, input its time by “tapping” it four times on the
TAP button. The LED flashes at tempo, so that you can understand visually if the
tempo is right. If the tempo was not entered correctly, the LED does not flash.
You can change the intensity of the effect by using the DEPTH knob. To
return to the default setting, press the DEPTH knob.
AMP MODEL type DRIVE knob
Amp1 (Clean Combo) PreVol
Amp2 (California) PreVol
Amp3 (Tweed) PreVol
Amp4 (AC30) PreVol
Amp5 (Modded OD) PreVol
Organ Amp (Korg OD/HG) Drive
MODULATION FX type SPEED knob INTENSITY knob
Chorus 1 Speed Depth
Chorus 2 Speed Intensity
Phaser 1 Speed Depth
Phaser 2 Speed Color (type 1, 2)
Flanger Speed Depth
Rotary Horn Speed Horn Accel
REVERB/DELAY type DEPTH knob
Room Mix
Plate Mix
Hall Mix
Spring Mix
Tape Echo Mix
St. Delay Mix
SV1-100-UserGuide-EFGI.book Page 25 Tuesday, June 30, 2009 9:23 AM