Kodak Scanners i800 Series - Manual (Page 55)

5-12 A-61169 July 2003
Replacing the feed
module and feed
module tires This section provides replacement procedures for the feed module and
the feed module tires.
Replacing the feed
module To replace the feed module:
1. Open the swing out door.
2. Push the release lever to the right to release the feed module.
3. Remove the feed module.
To install the new feed module:
4. Push the release lever to the right and reinsert the new feed module by
aligning the pins and fitting it into position. When the feed module is in
position, release the lever and be sure the feed module is securely in
place.
5. Close the swing out door.