Kodak Scanners i800 Series - Manual (Page 44)

A-61169 July 2003 5-1
5 Maintenance
This chapter provides cleaning and replacement procedures for your
scanner. For best scanner performance clean the areas outlined in this
chapter every 8-hour shift, unless otherwise noted.
Additional maintenance supplies can be ordering by calling DI Supply or
through your Kodak Reseller. For a list of available supplies, see the
section entitled, “Ordering Supplies” at the end of this chapter.
IMPORTANT: All cleaning supplies can be disposed of in your normal
waste management system, unless otherwise noted.
Use the green handles when accessing scanner
components.
Cleaning the paper
path The paper path should be cleaned with a Paper Path Cleaner fed several
times through the transport. To clean the paper path:
1. Remove the wrapping from the Paper Path Cleaner.
2. Adjust the feeder guides to the widest position.
3. Run the scanner in count-only mode. See Chapter 3, Operator
Control Panel Functions, for procedures.
4. Feed the cleaning sheet (adhesive side up) in the landscape
orientation several times through the transport.
5. Feed the cleaning sheet (adhesive side down) in the landscape
orientation several times through the transport.
NOTE: When a cleaning sheet gets dirty, discard it and use a new one.