Kodak DryView 8900 - Manual (Page 69)

Operation and Maintenance
January 10, 2006 5E6155 3-39
NOTE: When the Energy Save mode is activated, the imager shuts down
the film processor heaters and 30 minutes later shuts down the
processor drum motor. The Energy Save On screen is displayed
on the local panel. If the imager is in the Energy Save mode, it
automatically begins warm-up when a job is received. The imager
automatically returns to Energy Save mode when the job is
printed. The Energy Save mode will not be activated if there are
jobs pending in the Active, No Media, or Undelivered queues.
These jobs must be cleared or deleted by the Key Op, if they are
in the undelivered queue.
Energy Save On
Image Resizing Icons If an image has been resized or cropped, an icon appears on the bottom of
the film. There are three types of icons that appear.
• Crop. The image perimeter is removed to allow the image to fit on the
film and print at the same scale as the anatomical area of interest.
An image might be cropped if it is too large to print on the selected film
size, and the size of the area of interest is important to retain.
CAUTION :
If anatomical areas of interest are near an outer edge of the
image, they might be removed from the image when it is
printed.