Kodak DryView 8900 - Manual (Page 100)

4-30 5E6155 January 10, 2006
Troubleshooting
3. Release the two clamps at the left of the processor.
CAUTION :
Whenever you raise or lower the drum cover, grasp the
cover only on the lift handle to avoid the possibility of
pinching your fingers.
4. Open the drum cover.
CAUTION :
To prevent damage to the surface of the processor drum, do
not use any type of tool to remove jammed film.
5. Clear the jammed film from the processor area. There may be more
than one sheet.
NOTE: If the film is jammed in the lower section of Area 4, open the front
door to remove the film (see “Clearing Film Jams from Area 2” on
page 4-27 ).
6. Close the drum cover and secure it with the two clamps.
7. Close the hood.
8. If you cannot clear the jammed film, call an Authorized Service
Provider of Kodak products.
NOTE: The processor has to warm up to operating temperature before
the processor can print.