Konica Minolta 7075 - Manual (Page 218)

12-4 Shortcuts
Shortcuts
Chapter
(p. 9-8)
1 Touch APPLI. to display the Application selection screen.
2 Touch Chapter to display the Chapter page setting screen with 1-2 mode
automatically selected.
3 Use the keypad to enter the page number of the first title page, then touch SET .
4 Repeat Step 3 for each additional title page, touching SET after each entry.
5 Touch OK to return to the Application selection screen.
6 Make additional copying selections.
7 Touch
OK to return to the Basic screen.
8 Enter the print quantity amount.
9 Position (up to 100) originals face up on the RADF (document feeder) tray.
10 Press [ START ]. When copying is completed, press [ AUTO RESET ] to reset the machine.
Combination: Copy 2, 4 or 8 originals on 1 sheet
(p. 9-10)
1 Touch APPLI. to display the Application selection screen.
2 Touch Combination to display the Combination mode selection screen.
3 Touch 2 in 1 , 4 in 1 , or 8 in 1 .
4 Touch OK to return to the Application selection screen.
5 Make additional copying selections.
6 Touch
OK to return to the Basic screen with AMS automatically selected. You may
change this setting.
7 When all settings are correct, enter the print quantity amount.
8 Place original(s) face up on the RADF (document feeder) tray.
9 Press [
START ]. When copying is completed, press [ AUTO RESET ] to reset the machine.
Booklet
(p. 9-12)
1 First, load 11"x17" or 8.5"x11"R paper in a tray.
2 Touch
APPLI. to display the Application selection screen.
3 Touch Booklet to display the Booklet mode selection screen.
4 Touch NO COVER SHEET , COVER WITH COPY SHEET , or COVER WITH BLANK SHEET .
5 Select the cover sheet tray source and the binding mode, if required.
6 Touch
OK to return to the Application selection screen.
7 Make additional copying selections, or touch OK to return to the Basic screen.
8 Select 1-2 or 2-2 copy mode. To release AMS default, select magnification and copy
size.
9 Touch OUTPUT APPLI. to select folding or stapling & folding if the FS-108B Finisher
is installed, or to select trimming if the TU-108 Trimmer unit is installed.
10 Touch OK to restore the Basic screen, then enter the print quantity amount.
11 Position letter-size originals face up on the RADF (document feeder) tray, in portrait
orientation.
12 Press [ START ]. When copying is completed, press [ AUTO RESET ] to reset the machine.