Konica Minolta bizhub 160f - Manual (Page 274)

8 When a message appears
8-30 bizhub 160f
8.10 When incorrect copies are produced
Symptom Possible cause Action
The image is too light. The density level for the Auto
setting is set to “LIGHT”. Adjust the setting for DENSI-
TY LEVEL (A) in the utility
mode. (p. 7-23)
Otherwise, cancel the “Auto”
density setting, and then man-
ually select the desired densi-
ty setting. (p. 4-12)
The density level is set to light. Press the [)] key, and then
select a darker copy density.
(p. 4-12)
Does the message TONER
EMPTY appear in the dis-
play?
Change the toner cartridge
with a new one. (p. 8-7)
The paper is damp. Change the paper.
The image is too dark. The density level for the Auto
setting is set to dark. Adjust the setting for DENSI-
TY LEVEL (A) in the utility
mode. (p. 7-23)
Otherwise, cancel the “Auto”
density setting, and then man-
ually select the desired densi-
ty setting. (p. 4-12)
The density level is set to
dark. Press the [*] key, and then
select a lighter copy density.
(p. 4-12)
The original glass surface is
dirty. Wipe the original glass clean
with a soft, dry cloth.
The original is not held tightly
against the original glass. Place the original in position
so that it is held tightly against
the original glass.
The copy is blurry. The paper is damp. Change the paper.