Kodak Series 3 - Manual (Page 57)

Troubleshooting
www.kodak.com/go/support 50
Printing stops during
mid-print
(paper stops
feeding, and Paper
light may blink)
IMPORTANT: Use only Kodak color cartridge & paper kits for your printer
dock. Do not use inkjet paper.
■ Check the paper:
1 Remove the paper tray ( page 7 ).
2 Check the paper slot on the back of the printer dock.
3 Remove loose paper from the printer dock. If paper is jammed,
see
page 49 .
4 Inspect the paper supply: make sure removable tabs have not
been detached from the paper. Reload with new paper if
necessary.
5 Carefully "fan" the paper to keep the sheets from sticking
together.
6 Reload the paper tray. Do not exceed the fill line.
7 Re-install the paper tray, then press to resume printing.
■ Clean the paper feed roller ( page 46 ).
Print is smudged ■ Fingerprints may be on glossy side of paper. Handle paper by the
edges or by the removable tabs (
page 5 ).
Print is spotted ■ Check to see if the paper is dirty, and use a dry, lint-free cloth to wipe
clean. For excessive dirt or debris, thoroughly clean the paper tray,
and load new paper (
page 6 ). Check and clean the paper feed roller
if necessary ( page 46 ).
NOTE: When storing paper, remove and close the paper tray and paper tray door to keep
dust and debris from collecting on the paper or inside the printer dock ( page 5 ).
Problem Cause and/or solution