Kodak Series 3 - Manual (Page 11)

Getting started
www.kodak.com/go/support 4
Installing and removing the color cartridge
1 Open the cartridge door on the side of the printer dock.
2 Check to make sure there is no slack in the color
cartridge ribbon.
To remove slack, push in on the cartridge spool,
then rotate the spool clockwise.
IMPORTANT: Be careful not to rotate the spool more
than that necessary to remove slack. Doing
so could reduce the number of prints you
are able to make.
3 Slide the color cartridge in, label side up, with the
arrow pointing toward the printer dock. Push the
cartridge until it "clicks" into place.
4 Close the cartridge door.
■ To remove the color cartridge, open the cartridge
door, then push up on the green lever and slide the
cartridge out.
IMPORTANT: The color cartridge may lock in place if
there is a paper error. Do not attempt to
remove the cartridge without first clearing
the paper error. Make sure the Paper light
is off before attempting to remove the
cartridge (see Paper light under
Status
lights, page 58 ).