Siemens 4015 - Manual (Page 102)

101
Appendix
Gigaset 4015 Comfort, IM, A31008-G4015-J102-1- ANHA.FM 16.5.02
External telephone
numbers can not be di-
alled Number barring (mail-
box service) is activated Deactivate number bar-
ring
Telephone number
matches a call barring
number Compare call barring
numbers
Units/call charges are
not displayed Tariff information is
missing Request call charge
pulse transmission
from the telephone
company
You cannot hear The key
F
was
pressed – the micro-
phone is “muted”
Press
Î
, to activate
the microphone
The incoming call
number is not displayed
although CLIP is set. The telephone number
transmission is blocked The callers must permit
the transmission of
their telephone num-
bers at their network
provider
The ringer/dialling tone
cannot be heard. You have changed the
telephone cord on your
Gigaset. Ensure, when purchas-
ing a new cord, that it
has the correct pin as-
signment (3-4 assign-
ment of the telephone
leads/EURO CTR37).
Error beep is generated
(descending tone se-
quence) Wrong input Repeat the procedure;
note the display and, if
necessary, refer to the
operating instructions
The answering machine
announces “PIN is in-
correct” during remote
operation The system PIN en-
tered is incorrect or set
to 0000 Re-enter the system
PIN or set a PIN other
than 0000
The answering machine
does not record any
messages, announce-
ments or infotexts Memory is full Delete old messages
Play back and delete
new messages
An answering machine
message does not have
a time stamp Date/time not set Set date/time
Question Possible cause Possible solution