Sunwave Tech. SRC-7000 - Manual (Page 9)

Chapter 1 Introduction to the SRC-7000
7
1.3.1 Battery Precautions
Please pay attention to the following instructions:
1. Be sure that the positive (+) and negative (-) polarities of each
battery match the polarities indicated in the compartment.
2. Do not expose the batteries to excessive heat or flame.
3. Keep the batteries away from children.
4. Low power batteries will reduce the effective distance of the
unit.
5. Do not mix different type of batteries or mix new and used
batteries at the same time.
If you use Ni-MH rechargeable batteries, please pay
attention to the following.
a. Before the first use, please charge the batteries for 10
hours.
b. Do not recharge the batteries with an unqualified
charger.
c. When the battery low warning icon appears, please
recharge batteries right away.
d. Please renew the batteries immediately if the running
time is lower than half of the running time of a new fully
charged battery.
Warning: When the battery low warning icon appears, you
may not enter the Setup Menu to operate the functions
such as using learning function, adding a Macro, or
deleting devices.
1.4 Turning the Touch Screen On
Figure 1-2: Turning the LCD on
There are three ways to turn on
SRC-7000:
1. Picking up the SRC-7000. The
motion detector design will turn
the SRC-7000 on.
2. Pressing any rubber key.
3. Tapping the LCD touch screen.