Sunwave Tech. SRC-7000 - Manual (Page 11)

Chapter 1 Introduction to the SRC-7000
9
1.5.2 Botton of SRC-7000
Figure 1-4: Rear view
1. IR port
This needs to be pointed to the IR
receiver of the targeted device.
2. Reset switch
You can reset the SRC-7000 when
the SRC-7000 does not work
properly or hangs up (freezes).
3. Rear label
The rear label marks the model
number and the brief specifications.
4. Buzzer opening
Beep tone signals are transmitted
through here.
5. Battery compartment
Contains the 3xAAA Alkaline
batteries or Ni-MH rechargeable
batteries.
6. Learning eye (P.37)
The SRC-7000 learns the IR codes
from the original device through
this learning eye. Simply point the
original device to SRC-7000this
learning eye 2~4 inch apart and
press corresponded key on the
original device, and save the
corresponding code into the SRC-
7000.
In this way, SRC-7000 will learn the
IR codes from your original device.