Sunwave Tech. SRC-7000 User Manual

Page 22

Text mode
Original mode

SRC-7000 User’s Manual

If the codes are not correct please repeat steps and select

“All”. Repeat the ~ again to find the proper code for your

target device.

4. Finally, press the

button to load the code and exit.

If you didn’t get the correct remote codes from the
“Pre-programmed code list” item, or you did the wrong steps,
please try the other ways to re-setup or supplement.
a. Use Pre-code function to load current remote codes.

(Please refer to 3.1.2 A. Pre-code P.23.)

b. Use Learning function to learn all or part of correct

remote codes. (Please refer to 3.1.2 B. Learning P.25.)

Now you are able to control your devices by the SRC-7000. For

more information about advanced operation functions, please go to
the next chapter.