Sunwave Tech. SRC-7000 User Manual

Page 26

SRC-7000 User’s Manual

1. Decide the “Device Category” for your device by pressing the

buttons. Press the

to confirm and enter to

next step.

2. Decide how you will load the IR remote codes for the device.

Select “Pre-code” press

to confirm.

Choose the first letter of targeted device brand (ex. “S” on

behalf of Sony, Samsung…etc), and point the SRC-7000 at the

targeted device. After selecting “Brand” item, please turn on

your target device.

Tap

soft button to start auto searching. When you see the

targeted device has been turned off, tap or press any button
immediately to stop auto searching. Then press to test the

power key. If it can’t work, please go through step as below.

Tap

gently to figure out the correct remote code

(Code number as shown on the top middle position of the LCD.)

until the targeted device has been turned on again. Press the

power key or the hard key to test and to confirm the codes.

If the codes are not correct please repeat steps and select

“All”. Repeat the ~ again to find the proper code for your

target device.

4. If they work, it means that you have found the correct remote

codes. Please press the

button to confirm your decision.

When you are in step 3 you will see an icon located on
the top-right of LCD. It is “Key Pad Entry” function. (Please
refer to P.35 for more detail.)