Sunwave Tech. SRC-7000 - Manual (Page 19)

17
Chapter 2 Quick Start
This chapter shows you how to quickly set up the SRC-7000, for a more
detailed set up please refer to Chapter 3.
At turn on, the SRC-7000 will show the welcome greeting message on
the screen. From now on, you formally enter the setup procedure.
Please operate by the following instructions step by step.
2.1 Re-calibrating the Screen
You will need to re-calibrate SRC-7000’s touch panel in three conditions:
a. When you insert the batteries at the first time.
b. When you reset the SRC-7000.
c. When you feel the SRC-7000’s touch panel is not so sensitive.
Please follow the instruction as below:
1. Press
button for 2 seconds to enter Setup Menu.
2. Scroll the or buttons to choose Setting item and press
button for entering “Setting” menu.
3. Scroll the or buttons to select Calibrate item and
press button for entering “Calibrate Panel” for screen
calibration.
4. Tap the 5 “ ” places following screen indication step by step.
When finished, the screen will go back to previous “Setting” menu
automatically.
2. 3. 4.
When you finish tapping these 5 indicators, the re-calibration
process is completed. Then press
two times to exit setup
mode.