Sanyo C4272R S/C User Manual

Page 94

How to check for overlapping of central address Nos.

(1)

Press the

and

buttons at the same

time for more than 4 seconds.

and CODE No. C1 will flash.

(2)

Select CODE No. C3 by pressing

( ) button and press the

button.

C3 changes from flashing to ON state and

will flash. Then auto overlap checking will start.

(3)

If C3 changes from ON to flashing and

stops flashing and disappears, there is no over-

lapping.

Then finally, complete the auto overlap checking

mode by pressing the

button.

(4)

If some of GROUP No., ZONE No. and UNIT No.

flash, you should try the zone registration again.

Select CODE No. C1 by pressing

( ) button and press the

button.

Select the flashing GROUP No. with the ZONE

and GROUP buttons.

Then press the

button and reselect the

ZONE, GROUP and UNIT No.

Then finally, complete the auto overlap

checking mode by pressing the

button.

Fig. 8-11

07-115 SSHP_II 5/7/07 4:00 PM Page 94

This manual is related to the following products: