Sanyo C4272R S/C - Manual (Page 62)

62
RC
(WD)
6-3. Basic Wiring Diagram
Use shielded wires for inter-unit control wiring and
ground the shield on both sides. (Fig. 6-5)
Otherwise misoperation because of noise may occur.
■ Wiring procedure
Install the wiring according to the above wiring diagram.
● Address setting is automatically executed after turn-
ing on the system.
An indoor unit address is assigned to each indoor
unit.
● Operation takes place successively at intervals of 1
second, by using combinations of the address setting
of each unit.
CAUTION
Carry out wiring correctly
(incorrect wiring will damage
the equipment).
■ Diagram of outer dimensions
5/32
4-23/32 5/8
2
3/
3
2
3/
3
2-
4
Fig. 6-5
Shielded wire
Ground Ground
Unit: inch
07-115 SSHP_II 5/7/07 4:00 PM Page 62