Sharp FO-4650 - Manual (Page 88)

Relay Request
86
Relay Broadcast
The fax machine can also act as a relay station. It will receive a
document from a fax machine requesting a relay transmission, and
automatically broadcast it to the stations that the requesting machine
specifies.
To enable a fax machine to request a relay transmission, you must first
enter its fax number in the Relay Passcode List. Follow the steps
below to enter or clear a fax number.
♦ When your fax receives a relay request from another fax machine,
RCVD RELAY REQUEST will appear in the display.
♦ If the telephone billing function is turned on, the fax machine can-
not act as a relay station.
♦ To clear a fax number from the Relay Passcode List, you need to
know the 2-digit number which identifies it. You can check this
number by printing out the Passcode List (see Chapter 7).
1
Press these keys:
The display will show:
4:RELAY PASSCODE
1=SET, 2=CLEAR
U
RELAY
4
6
Press the START key to send the
document through memory, or the
DOCUMENT key to send the
document directly from the feeder.
DOCUMENT
or
START
all-FO4700.book Page 86 Tuesday, November 28, 2000 2:07 PM