Sharp FO-4650 - Manual (Page 153)

Optional Settings
151
6. O
p
ti
on
Setti
ngs
Setting 26: TELEPHONE BILLING CODE
This setting allows you to use Department Codes or direct billing
codes for telephone billing on a PBX. (Your dealer must first activate
Department Control or direct billing code entry.) Press 1 to turn
telephone billing on, or 2 to turn it off.
♦ Initial setting: 2
If you pressed 1, the BILLING CODE DIAL selection will
subsequently appear. Press 1 if your PBX must receive the billing
code before dialing a telephone number, or 2 if it must receive the
billing code after dialling a telephone number. (Refer to your PBX
manual or consult your PBX adminstrator for this information.)
Note: If you select AFTER for the BILLING CODE DIAL selection, you
must press the REDIAL key after dialing if you use the SPEAKER key.
Setting 27: DEPARTMENT CODE DIGITS
Use this setting if you are using Telephone Billing and need to change
the number of digits of Department Codes to accord with your PBX’s
telephone billing system. Enter any number from 3 to 9.
♦ Initial setting: 4
Setting 28: DISTINCTIVE RING
This sets the ring pattern to which your fax will answer if you
subscribe to a distinctive ring service. Enter a number from 1 to 5 to
select a pattern. See Distinctive Ring in Chapter 5 for more details.
♦ Initial setting: 5
all-FO4700.book Page 151 Tuesday, November 28, 2000 2:07 PM