Sun Microsystems Sun StorEdge A3500FC User Manual
Sun storedge
Table of contents
Document Outline
- Sun StorEdge™ A3500/A3500FC Hardware Configuration Guide
- Contents
- How This Book Is Organized
- Using UNIX Commands
- Typographic Conventions
- Shell Prompts
- Related Documentation
- Sun Documentation on the Web
- Sun Welcomes Your Comments
- 1.1 Configuration Guidelines
- 1.2 Supported SCSI Host Configurations
- 1.3 Ultra 2 Host System Power Connection Requirement
- FIGURE15 AC Power Sequencers—Ultra 2 Power Connector
- 1. Gain access to the AC power sequencers.
- 2. Route the power cable from the Ultra 2 host under the expansion cabinet frame on the same side...
- 3. Connect the power cord from the Ultra 2 host into the top power connector of either power sequ...
- 4. Reassemble the expansion cabinet.
- 2
- FC-AL Host Connections
- 2.1 Configuration Guidelines
- 2.2 Supported FC-AL Host Configurations
- 2.2.1 Single Host Connected to One Controller Module
- 2.2.2 Independent Controller Module Connected to Two Hosts
- 2.2.3 Single Host Connected to One Controller Module Using Hubs
- 2.2.4 Single Host Connected to Two Controller Modules Using Hubs
- 2.2.5 Single Host Connected to Four Controller Modules in a Loop Using Hubs
- 2.2.6 Multi-Host
- 2.3 Setting the Loop ID
- 3.1 StorEdge D1000 Disk Array Settings
- 3.2 1x2 Cables and Connections
- 3.3 1x5 Cables and Connections
- 3.4 2x7 Cables and Connections
- 3.5 3x15 Cables and Connections
- 3.5.1 SCSI Cable Lengths
- TABLE310 Controller Module A (3x15 Configuration) Cables
- TABLE311 Controller Module B (3x15 Configuration) Cables
- TABLE312 Controller Module C (3x15 Configuration) Cables
- FIGURE319 Controller Module A—3x15 Configuration
- FIGURE320 Controller Module B—3x15 Configuration
- FIGURE321 Controller Module C—3x15 Configuration
- 3.5.2 Connections Between Power Sequencers
- 3.5.3 Connections to AC Power Sources
- 3.5.4 Power Connections for Expansion Cabinets
- 3.5.1 SCSI Cable Lengths
- A.1 Initial Cold Start Surge Current Specifications