Cleaning the lamp module and projector vents – Smart Technologies Smart Board Interactive Whiteboard Systems 600i4 User Manual
Page 97
81 |
CHAPTER 6 – MAINTAINING YOUR INTERACTIVE WHITEBOARD SYSTEM
Cleaning the Lamp Module and Projector Vents
This section provides instructions for using a vacuum cleaner to remove accumulated
dust from the SMART UF65 or SMART UF65w projector’s lamp module, vents and
slots. SMART recommends cleaning your projector every six months. If your projector
is regularly exposed to dust, clean it every three months.
IMPORTANT
This procedure is intended for qualified installers only.
To clean the projector you must:
•
remove the projector from the boom (page 82)
•
access the lamp module (page 84)
•
vacuum the lamp module and projector vents (page 85)
•
replace the lamp module and lamp cover (page 86)
•
replace the projector (page 87)
You require a Phillips No. 2 screwdriver to perform the following procedure.