beautypg.com

Smart Technologies Smart Board Interactive Whiteboard Systems 600i4 User Manual

Page 109

background image

93 |

CHAPTER 7 – REPLACING THE SMART UF65 OR SMART UF65W PROJECTOR
LAMP

4. Put the old lamp in a secure container. Handle the old lamp gently until you

recycle or dispose of it.

IMPORTANT
Recycle or dispose of the lamp module according to your local
waste authority.

5. Remove the replacement lamp module from its packaging.

CAUTION
Do not touch any part of the lamp module except the housing.

6. Place the replacement lamp module in the lamp slot, push the lamp all the way

down, and then tighten the lamp locking screws until they’re secure.

7. Replace the outer lamp cover.

NOTE
You may need to adjust the projected image after performing the previous
procedures. For more information, see the included

SMART Board 600i4 and

D600i4 Interactive Whiteboard System Installation Instructions

and the tips on

page 16.

8. Replace the projector on the boom and connect the cables. See page 87.

This manual is related to the following products: