Powerstate controls – Smart Technologies Smart Board Interactive Whiteboard Systems 600i4 User Manual
Page 60

44 |
CHAPTER 4 – REMOTELY MANAGING YOUR INTERACTIVE WHITEBOARD
SYSTEM
Powerstate Controls
These commands turn on or turn off the projector and request the projector’s current
powerstate. The projector’s powerstate determines whether or not certain commands
are available at that time. These settings are always available, even when the
projector is off.
Powerstate Command Description
Powerstate Response Field Description
Command
Response
on
powerstate=[field]
off
powerstate=[field]
off now
powerstate=[field]
get powerstate
powerstate=[field]
Command
Description
on
Turns on the projector.
off
Starts the shutdown process. A dialog box appears with the
message, “Press Power Button to Turn off Projector.”
You must send a second Off command within 10 seconds
to completely turn off the projector.
off now
Shuts down the projector immediately. You can’t delay or
cancel this command.
get powerstate
Indicates the projector’s current powerstate.
Field
Description
Powering
The projector is turning on.
On
The projector is on.
Cooling
The projector is cooling.
Confirm off
Confirm off is a non-selectable powerstate that is returned
during stage one of the two-button off sequence.
Idle
The projector is off but still receiving power (standby).