Network controls, Network information commands, Network control commands – Smart Technologies Smart Board Interactive Whiteboard Systems 600i4 User Manual
Page 66

50 |
CHAPTER 4 – REMOTELY MANAGING YOUR INTERACTIVE WHITEBOARD
SYSTEM
Network Controls
These commands control your projector’s network status and settings. These settings
are always available, even when the projector is off.
Network Information Commands
These commands inform you of the current network settings.
Network Control Commands
These commands control your network settings.
Command
Response
get netstatus
netstatus=connected
netstatus=disconnected
netstatus=disabled
get dhcp
dhcp=[current DHCP status]
get ipaddr
ipaddr=[current IP address]
get subnetmask
subnetmask=[current subnet work mask number]
get gateway
gateway=[current network gateway]
get primarydns
primarydns=[current primary domain name number]
get macaddr
macaddr=[current MAC address]
Command
Command Target Range Response
set dhcp [target]
=on
=off
dhcp=[current]
set ipaddr [target]
=0.0.0.0 to
=255.255.255.255
ipaddr=[current]
set subnetmask [target]
=0.0.0.0 to
=255.255.255.255
subnetmask=[current]
set gateway [target]
=0.0.0.0 to
=255.255.255.255
gateway=[current]
set primarydns [target]
=0.0.0.0 to
=255.255.255.255
primarydns=[current]