Vacuuming the lamp module and projector vents – Smart Technologies Smart Board Interactive Whiteboard Systems 600i4 User Manual
Page 101
85 |
CHAPTER 6 – MAINTAINING YOUR INTERACTIVE WHITEBOARD SYSTEM
3. Pull up on the lamp module’s handle, and then remove the lamp.
4. Gently place the lamp module on your work area with the handle facing
downward.
Vacuuming the Lamp Module and Projector Vents
After you remove the lamp cover and lamp module, vacuum the lamp module and
projector vents.
To vacuum the
lamp module and
projector vents
1. Use a vacuum cleaner to thoroughly vacuum each side of the lamp module for
10 seconds.
This manual is related to the following products: