Smart Technologies Smart Board Interactive Whiteboard Systems 600i4 User Manual
Page 108

92 |
CHAPTER 7 – REPLACING THE SMART UF65 OR SMART UF65W PROJECTOR
LAMP
You require a Phillips No. 2 screwdriver to perform the following procedure.
To remove and replace
the projector lamp module
1. Remove the outer lamp cover with your finger and set it aside.
2. Using a Phillips No. 2 screwdriver, loosen the two screws on the inner lamp
module. The screws remain captive inside the lamp module.
3. Pull up on the lamp module’s handle, and then remove the lamp.
This manual is related to the following products: