Sony SNC-CS20 - Manual (Page 33)

A
d
mini
s
tra
ting
t
he
Came
ra
Configuring the System — System Menu
33
Notes
• When you superimpose the image, the image frame
rate may be reduced.
• The size of the superimposed characters is reduced if
the image size is set to less than 640 × 480 (VGA) or
less.
• When you have changed the Date & Time setting,
click Refresh of the Web browser to reflect the change
on the opening main viewer.
• Enter alphanumeric characters, - (hyphen), / (slash), _
(under score), : (colon) and a space for the camera ID.
• When the image size is set to JPEG - 1280 × 960
(Quad-VGA) : MPEG4 - OFF : JPEG cropping
available (page 40), you cannot set superimpose.
OK/Cancel
See “Buttons common to every menu” on page 28.
Installation Tab
You can perform the settings related on the installation.
Display sample: SNC-DM160
Video output mode
You can set the output signal from the analog video
output connector of the camera.
IP only: Outputs via network only.
NTSC + IP: Outputs with NTSC signal system.
The image setting output from the network is limited.
When this mode is selected, Analog video setting is
enabled and set. (SNC-DM110 / DM160 / CM120
only)
PAL + IP: Outputs with PAL signal system. The image
setting output from the network is limited. When this
mode is selected, Analog video setting is enabled
and set. (SNC-DM110 / DM160 / CM120 only)
Note
When Video output mode is NTSC + IP or PAL + IP,
the setting items for the image output from the network
are limited. For details, see Video codec tab. (page 40)
Tip
Video output mode can be changed by the switch on the
camera. For details, refer to the supplied Installation
Manual.
Analog video setting (SNC-DM110 / DM160 /
CM120 only)
You can set about the analog output image. When you
switch the status of Light funnel function, the sensitivity,
image quality and frame rate of the analog output image
are changed.
When you click Light funnel, the Light funnel mode
setting menu is displayed.
Display sample: SNC-DM160
When the image quality has priority, select Always off
(Priority: Image quality). When the frame rate and
sense have priority, select Always on (Priority: Frame
rate, sensitivity). For other items or settings, see Sense
up tab of “Camera menu” (page 38).
Note
The Light funnel setting is applied for the image output
from the network.
Iris open
You can open the iris of the auto iris lens for focus
adjustment.
On: Opens iris.
Off: Without iris open.
When you set Iris open to On, the focus assist indicator
appears to show the degree of focus adjustment.
When Video output mode is NTSC + IP or PAL + IP,
the focus assist indicator appears on the image output
from the analog video output connector. When Video
output mode is IP only, the focus assist indicator
appears on the image output from the network.