State Industries SBD85 500 - Manual (Page 34)

SBD TANK TYPE HEATERS
SERVICE HANDBOOK
Technical Training Department
Ashland City, TN ©2003
33
STEP 13 PILOT SPARK TEST
STEP 13. PILOT SPARK TEST. Visually check for spark at the pilot assembly.
Note: The pilot burner mounts on the left side of the main burner.
IF THEN
The igniter is not sparking:
Check for:
•
A 7/64” spark gap
•
Spark cable continuity
•
Ground cable continuity
Sparking is present:
•
Go to step 14.
Power To Module May Be Interrupted To Reset .
Trial for Ignition
90 sec. 5 min. 90 sec. 5 min. 90 sec.
Call for
heat
Sparking
No
Sparking
Sparking
No
Sparking
Sparking Continuous
Trial
Sequence