Sun Microsystems X4150 - Manual (Page 49)

Chapter 3 Setting Up the Sun Fire X4150 Server 39
10. To assign a static IP ADDRESS, type the following commands in exact order:
ELOM:
set /SP/network IPSource=static
set /SP/network IPAddress= xxx.xxx.xxx.xxx
set /SP/network Netmask= xxx.xxx.xxx.xxx
set /SP/network Gateway= xxx.xxx.xxx.xxx
Where xxx = IP address numbers
ILOM:
set /SP/network/ pendingipdiscovery=static
set /SP/network/ pendingipaddress= xxx.xxx.xxx.xxx
set /SP/network/ pendingipnetmask= xxx.xxx.xxx.xxx
set /SP/networks/ pendingipgateway= xxx.xxx.xxx.xxx
set /SP/networks/ commitpending=true
Where xxx = IP address numbers
Example 2
To change the service processor (SP) static IP address to a DHCP IP address using
the serial connection (system management port), perform the following steps:
1. Connect a terminal (or a PC running terminal emulation software) to the server
serial port.
2. Ensure that the server hardware is installed and cables are inserted.
3. Verify that your terminal, laptop, PC, or terminal server is operational.
4. Configure the terminal device or the terminal emulation software running on a
laptop or PC to the following settings:
■ 8,N,1: eight data bits, no parity, one stop bit
■ 9600 baud
■ Disable hardware flow control (CTS/RTS)
■ Disable software flow control (XON/XOFF)
5. Connect a null serial modem cable from the server’s back panel serial
management to a terminal device (If not connected already).
See FIGURE 1-4 for the serial port position.
6. Press Enter on the terminal device to establish a connection between the
terminal device and the LOM SP. The prompt appears.
->