Sun Microsystems X4150 - Manual (Page 23)

Chapter 2 Installing the Sun Fire X4150 Server Into a Rack with Slide-Rails 13
Installing the Mounting-Brackets Onto the Server
To install the mounting-brackets onto the sides of the server:
1. Position a mounting-bracket against the chassis so that the slide-rail lock is at
the server front, and the three keyed openings on the mounting-bracket are
aligned with the three locating pins on the side of the chassis.
FIGURE 2-2 Aligning the Mounting-bracket With the Server Chassis
2. With the heads of the four chassis locating pins protruding though the four
keyed openings in the mounting-bracket, pull the mounting-bracket toward the
front of the chassis until the mounting-bracket clip locks into place with an
audible click. (See
FIGURE 2-2 .)
3. Verify that the rear locating pin has engaged the mounting-bracket clip. (See
FIGURE 2-2 .)
4. Repeat to install the remaining mounting-bracket on the other side of the
server.
Chassis front
Slide-rail lock
Mounting-
Mounting-bracket
bracket clip