Samsung ML 7300N - Manual (Page 25)

S ETTING U P Y OUR P RINTER
2.8
To print from computer software, you need to connect your printer to your
computer with a parallel interface cable.
The parallel cable should be compatible with the Centronics R parallel interface
and IEEE standard 1284. If you purchase a parallel cable, ensure that it :
• Is compatible with Centronics interface.
• Supports bi-directional communications(IEEE standard 1284).
• Is shielded.
• Has the appropriate connector :
- 25 pin D-Sub connector on the computer side.
- Amphenol 36 connector on the printer side.
Connecting the Parallel Cable
Cable Specifications (Not provided)
Connecting the Parallel Cable
2 Plug the appropriate end of the
parallel cable into the connector on
the rear of the printer.
To connect the printer to your computer use a parallel cable and
proceed as follows.
1 Check that both the printer and the computer to which it is to be connected
are powered off and disconnected from the power point.