SATO DR300 - Manual (Page 47)

DR300 Operator Manual
45
[10] Factory Mode
To enter this mode, set DIPSW 2-5 to ON position. Open thermal print head, power on
while pressing both and keys. Release both keys when buzzer beeps.
The LCD display will show “HEAD OPEN” message, close the thermal print head and
“FACTORY MODE” will be displayed. Set DIPSW 2-5 top OFF position.
NON ALL HEAD CUT
Press key to confirm the clear item.
Press key to print a test sample.
Press key to stop/pause printing.
FACTORY
MODE
FACTORY
NON
FACTORY
PRINT
ALL, HED, CUT
Chapter 8 - Operation Panel