SATO DR300 - Manual (Page 41)

DR300 Operator Manual
39
[6] Setting Default Value
To enter this mode, power on printer while holding down and keys
simultaneously.
Press and keys when power on printer, buzzer sounds, and press
key to move cursor to [YES]. Confirm by pressing key.
[7] Setting Service Mode (Default & Service Mode)
To enter this mode, power on printer while holding down and keys
simultaneously.
Press and keys while power on printer,
buzzer sounds and press key to move cursor to
[NO]. Confirm by pressing key.
Setting
sensor level
key : proceed to pitch
adjustment setting.
key : selection of sensor
level and threshold
level.
DEFAULT
NO YES
DEFAULT
COMPLETE
DEFAULT
NO YES
SERVICE
MODE
Tctr [0.0v]
TH [0.0v]
SERVICE
LVL SET
FEED key
FEED key
FEED key
LINE key
Chapter 8 - Operation Panel