Woodstock W1811 - Manual (Page 56)

-54-
N(/((('Jc`[`e^KXYc\JXn
J
M
@:<
J
This section covers the most common service adjustments
or procedures that may need to be made during the life
of your machine.
If you require additional machine service not included
in this section, please contact Woodstock International
Technical Support at (360) 734-3482 or send e-mail to:
k\Z_$jlggfik7j_fg]fo%Y`q.
>\e\iXc
D8B< JLI< k_Xk pfli dXZ_`e\ `j
legcl^^\[ [li`e^ Xcc j\im`Z\ gifZ\$
[li\j @] k_`j nXie`e^ `j `^efi\[# j\i`$
fljg\ijfeXc`ealipdXpfZZli%
DX`e9\ckI\gcXZ\d\ek
(% DISCONNECT SAW FROM POWER!
)% Tilt the blade to 45˚ and lower it as far as it will go.
*% Remove the motor cabinet door.
+% Loosen the pivot bolt and two adjustment bolts
( =`^li\0*).
Efk\1;FEFKcffj\ek_\j\Yfckjdfi\k_Xe ( Ð
)
fi
pflilek_\i`jbf]k_\dfkfidflekYfckjZfd`e^
flkf]k_\`i_fc\j#n_`Z_n`ccY\[`]]`Zlckkfk_i\X[
YXZb`e%
,% Push and hold the motor all the way up to relieve
tension on the belt, remove the belts from the top
pulley, and squeeze them between the lower pulley
and casting.
-% Fit the new belts onto the pulleys in the same man-
ner that you removed the old belts.
.% Push down on the motor with one hand, and tighten
the adjustment and pivot bolts with the other hand
or have someone help you. The belts should be tight
enough that they only deflect approximately
1 ⁄
4
"
when pushed in the center with your thumb or index
finger with moderate force.
/% Replace the motor cabinet door.
9\ckJ\im`Z\
Glcc\p
;\]c\Zk`fe
Glcc\p
=`^li\0+% Checking belt deflection.
=`^li\0*% Main blade belt tension
controls (table removed for clarity).
Adjustment
Bolt
Pivot
Bolt
Adjustment
Bolt