Woodstock W1811 - Manual (Page 22)

-20-
N(/((('Jc`[`e^KXYc\JXn
J<
K
L
G
()% Slide the rip fence base on the rail, and check the
spacing between the rip fence base and scale bar
(see
=`^li\(0). There should be a minimum of 1 ⁄
8
"
of space between the scale bar and the fence base.
Adjust the mounting position of the rip fence rail
to create this space evenly along the length of the
scale bar, then tighten the rail mounting nuts.
=`^li\(0% Fence base installed; spacing
between fence base and scale bar.
Spacing
Efk\1K_\]\eZ\j_flc[jc`[\jdffk_cpfek_\iX`c2
`]`k[f\jek#i\dfm\k_\]\eZ\YXj\Xe[X[aljkk_\
jgi`e^gi\jjli\gcXk\dflek`e^gfj`k`fefek_\]\eZ\
YXj\j\\=`^li\)' #Ypcffj\e`e^k_\knfjZi\nj
Xe[i\gfj`k`fe`e^k_\gi\jjli\gcXk\jc`^_kcp%
=`^li\)(% Rip fence installed on fence
base.
T-Bar
Rip Fence
Lock Levers
(*% Thread the rip fence lever into the fence base
( =`^li\)'), tighten the hex nut against the rip
fence base to keep the lever in place.
(+% Slide the rip fence on the fence base T-bar as
shown in =`^li\)(. Use the two lock levers on the
opposite side of the fence base to secure the fence
in position.
=`^li\)'% Location of spring pressure
plate for fence slide adjustments.
Rip Fence
Lever
Spring Pressure
Plate