Woodstock W1811 User Manual
Page 25
-23-
N(/((('Jc`[`e^KXYc\JXn
J<
K
L
G
),% Attach the sliding table handle, as shown in =`^li\
*', with two premounted button head screws and
flat washers.
)+% Remove the shipping brace from the sliding table
(
=`^li\)/), then install the sliding table end cover
over the fixed part of the sliding table end, as shown
in
=`^li\)0, using the pre-mounted hardware.
=`^li\)0% Sliding table end cover
installed.
=`^li\*'% Sliding table handle attached
to end of sliding table.
Button Head
Cap Screws
)-% Thread two M5-.8 x 12 cap screws with 5mm lock
washers through the switch bracket and into the
sliding table base, and tighten the cap screws (see
=`^li\*().
=`^li\*(% Magnetic switch installed.
Magnetic
Switch
=`^li\)/% Sliding table shipping brace.
Shipping
Brace